select the protocols,and then click infor

where did you get the file?

If ecu is not encrypted, it supports

You have to wait a little while. You're going to hear a clap in the box, and it's going to light up. The process takes longer than with the KT200.

Yes, it will work.

hello
glad to help you.Is there any error message?

Theoretically, it is supported

Bench mode, make a full backup of the calculator in case of trouble.

Go to ecuhelpshop website, download vc_resist both version x64 and x86 and latest software for kt200II. Make sure disable antivirus and firewall.
If you have offline version all offline files must go to online folder. First attempt to open program with internet connection, you can follow the guide below: https://www.ecuhelpshop.com/product-technical/kt200ii-offline-software-auto-close-solution.html

hello,donot worry,no annual fee

Only 9hp is working.

I've done 1 MD1CS003 PSA, dated 12/2020. It was version 035, which is a newer date but older software. Versions 037 and 039 are the newer (locked) versions.

Yes works fine.

Boot mode.

Yes, that's fine. I've done one before and noticed that some ECU files are only half the size. There shouldn't be any issues.

KT200 will read and write BMW ZF 8HP via OBD and bench, but this protocol is not for cloning, only for tuning.
KT200 can read/write ZF 8hp (OBD) Only flash. You need read/write Eeprom, isn and vin too.
Read/write flash+coding data, but only the same tcu, only for chip tuning, need write codding data too.bench or obd2.

It will write the file even if the checksum is wrong. If you don't have a full reading, you risk bricking the ECU, so be careful. Ask your tuner for advice on what to do. Normally, the tool does this automatically.

The KTM bench tool skips the OTP protection area, which is why it writes successfully.
The manual solution is to use WinOLS. While Swiftec is expensive, it is not always perfect. The checksum from the tool works fine if it compares with orginal file.

laptop or desktop with Windows 10 is recommended.